聚合物水泥防水涂料是采用进口建筑专用聚合物乳胶为主要原料，配以多种助剂精制而成的防水乳胶，配合一定比例的普通硅酸盐水泥复合而成的新一代环保防水涂料，涂刷在基面上可形成高强坚韧的防水涂膜。
Introduction
The modifier is made up of imported polymer latex and several auxiliary agents, matching with some proportion common silicate cement could produce a new generation environmental waterproof material, and form strong and firm waterproof film.
产品特点
1、具有优良的粘结性、抗渗性、抗裂性、耐久性。
2、能在潮湿、干燥的多种材质基面上施工。
3、无毒、无味、无污染、施工简单、工期短。
4、在立面、斜面上施工不流淌。
Features
1. Able to construct on damp or dry surface;
2. Good viscosity, impermeability, crack resistance and durability;
3. No toxicity, no flavor, no pollution, easy to construct and short construction period;
4. no liquid flow on façade and slope.
适用范围
适用于各种屋面、地下室、厨房、卫生间、水池、游泳池及外墙防水工程和室内地面防潮层。
. Rooftop,, basement, bathroom, water tank, swimming pool,inner and outer wall, indoor floor .
施工方法
1、基层处理：基层表面平整结实、无蜂窝、麻面、干净、无尘土和油污。阴阳角做成圆弧形，施工前对基层缺陷部位要先进行修补。
2、底涂处理：在基面上按乳胶：水泥：水＝1：2：0.8的比例涂刷一遍，以增加基本的平整度和粘接力。
3、防水涂料的配制：按乳胶：水泥=1：0.7的重量比，用搅拌器搅拌均匀细腻，无粉团即可使用。
4、涂刷施工：将配好的防水涂料用棕刷或滚筒均匀涂刷在基面上，一般涂刷三遍，达到设计防水规范要求。
Methods
1. Clean the surface with no oil dirt, the surface should be flat and firm and no honeycomb. the iternal angle and externl angle should made to be circular arc and defect place should be repaired before instruction.
2. primary coat process: paint as proportion: latex: cement: water=1：2：0.8, to increase planeness and adhesion.
3. formulating: weight proportion of latex: cement= 1: 0.7, stir with blender until it is even and smooth and no powder dumpling.
4. paint and brush: coat the matched waterproof paint on base plane with palm fiber brush or roller., usually three times to reach waterproof requirement.
注意事项
1、乳胶液在使用前搅拌均匀。
2、水泥应选32.5R以上普通硅酸盐水泥或矿渣水泥（火山灰质水泥及早强水泥不宜用）。
3、乳胶液应储存在阴凉处，保质期为12个月。
Cautions
1. Stir the latex evenly before construction, do NOT add water inside;
2. It’s advised to use 3.25R (or above) Portland cement or slag cement (eruption cement/early strength cement is not advised);
3. Store the latex in cool places, storage period: 12 months.
